Filter
Top Products
About Your System 41
Unsupported CPU
combination
Unsupported CPU
stepping detected
Microprocessor(s) is not
supported by the system.
Install a supported
microprocessor or
microprocessor
combination. See
"Installing a Processor" on
page 101.
Utility partition
not available
The <F10> key was
pressed during POST, but
no utility partition exists
on the boot hard drive.
Create a utility partition on
the boot hard drive. See the
CDs that came with your
system.
Warning: Following
faulty DIMMs are
disabled:
CPU
n
: DIMM
n
CPU
n
: DIMM
n
Total memory size
is reduced.
Faulty or improperly
seated memory module(s)
used by CPUn.
See "Troubleshooting
System Memory" on
page 156.
Warning! No
microcode update
loaded for
processor
n
Microcode update failed. Update the BIOS firmware.
If the problem persists, see
"Getting Help" on
page 179.
Warning: One or
more faulty DIMMs
found on CPUn
Faulty or improperly
seated memory module(s)
used by CPUn.
See "Troubleshooting
System Memory" on
page 156.
Warning: The
installed memory
configuration is
not optimal. For
more information
on valid memory
configurations,
please see the
system
documentation on
the technical
support web site.
Invalid memory
configuration. The system
will run but with reduced
functionality.
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 92. If the problem
persists, see
"Troubleshooting System
Memory" on page 156.
Table 1-8. System Messages (continued)
Message Causes Corrective Actions