Filter
Top Products
136 Installing System Components
• Chassis intrusion switch cable
• SATA interface cable
8
Install all expansion cards. See "Installing an Expansion Card" on page 78.
9
Reinstall the SAS controller card. See "Installing a SAS Controller Card"
on page 112.
10
If applicable, reconnect the RAID battery cable to the SAS controller card.
11
If applicable, reinstall and connect the RAC card. See "Installing an
Optional RAC Card" on page 83.
12
Reinstall the NIC daughter card. See "Installing the NIC Daughter Card"
on page 89.
13
Install the optical drive carrier.
Slide the drive carrier into its drive bay and press in the release latch. See
Figure 3-20
.
14
Install the SAS hard drives in their original locations. See "Installing a Hot-
Plug Hard Drive" on page 109.
15
Replace the riser board.
16
Replace the cooling shroud assembly. See "Replacing the Cooling Shroud
Assembly" on page 70.
17
Replace the PEM.
18
Close the system. See "Closing the System" on page 66.
19
Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
20
Replace the bezel. See "Removing and Replacing the Optional Front
Bezel" on page 64.