Filter
Top Products
90 Installing System Components
Figure 3-18. Installing and Removing a NIC Daughter Card
5
Straighten the card so that the cutouts on the side edges of the card insert
into the two support standoffs. See Figure 3-18.
6
Slide the card back slightly and align the front edge of the NIC card with
the two front plastic retention standoffs adjacent to the system board
connector, and press down the side of the card until it is fully seated. See
Figure 3-18.
When the front of the card is fully seated, the plastic standoff snaps over
the edge of the card.
7
If applicable, reinstall the expansion cards in slots 6 and 7. See "Installing
an Expansion Card" on page 78.
1 retention standoff (2) 2 NIC daughter card connector
3 retention standoff holes (2) 4 NIC daughter card
5 support standoff 6 cutout
5
4
1
2
6
3