EMC AX150 Series Network Card User Manual


  Open as PDF
of 1015
 
23. BIOS 2.02a1
24. Firmware Version 1.92a1
25. Legacy (x86) boot mode supported only for this server. EFI boot is not supported. EFI boot code should be removed from the HBA if installed.
26. Firmware Version 2.80a4
27. Single node support only with Emulex 4Gb HBAs
28. HPQ (Compaq) Proliant server models that are not listed in the ESM but are only differentiated from supported models by an "R" designator, are rack−mountable servers and are
supported.
29. BIOS 2.01a2
30. Firmware Version 1.91a5
31. BIOS 1.71a0
32. When booting from an external storage array, press F1 during server POST and set BIOS Start Options to point to the bus slot containing the SAN boot adapter (Default is Planar
SCSI.)
33. Due to the HS20's embedded FC−SW design, array lun masking is required to assign LUNS to each individual blade server.
34. Refer to EMC Knowledgebase ID emc105679 for any special HBA drivers that may be required.
35. Dual−port FC switch module. Can be used in place of Optical PassThru Module (OPM.)
36. Firmware Version 1.10a5
37. x64 versions of Windows 2003 require the Adaptec SAS SCSI driver from the IBM Support website.
38. Support for 4GB fibre channel HBAs requires an IBM SPORE to be submitted to IBM with a request of system BIOS 56A.
39. This HBA is equivalent to the QLogic QLA2340.
40. BIOS 1.52
41. FSC Fibre Channel module. Dual channel 2GBit/s HBA for BX6xx−series blade servers only.
42. EMC supported drivers, firmware, and boot BIOS can be downloaded from http://www.emulex.com in the EMC section, by obtaining the supported driver for the Emulex LP1050−E.
43. BIOS 3.03a7
44. BIOS 2.06
45. Driver Version 9.1.7.26 Requires Microsoft STORPort hotfix Q943545. Please see http://support.microsoft.com/kb/943545. NOTE: Hotfix Q943545 requires a minimum of Service
Pack 1 (SP1) to be installed before the hotfix can be installed.
To obtain this hotfix, fill out the hotfix request form at http://support.microsoft.com/hotfix/KBHotfix.aspx?kbnum=943545&kbln=en−us STORPort Miniport Driver
46. Please see the HP website for supported BL c−Class model numbers.
The supported model numbers are available in the quickspecs documents available for each BL c−Class blade.
47. BIOS 1.26
48. BIOS Multiboot v6.00a5 (3.00a4/4.00a1)
49. BIOS 1.23
50. BIOS 2.02a2
51. Driver Version 1.30a9 Requires Microsoft STORPort hotfix Q943545. Please see http://support.microsoft.com/kb/943545. NOTE: Hotfix Q943545 requires a minimum of Service Pack
1 (SP1) to be installed before the hotfix can be installed.
To obtain this hotfix, fill out the hotfix request form at http://support.microsoft.com/hotfix/KBHotfix.aspx?kbnum=943545&kbln=en−us STORPort Miniport Driver
52. This HBA is equivalent to the QLogic QLA2310.
53. Emulex PCI−X and PCI−Express adapters including Qlogic 4Gb PCI−X and PCI−Express adapters are supported in the x346 (8840) only when IBM ServerRAID−7K (71P8642 or
30R8800) is installed with most current firmware and BIOS.
54. BIOS 1.43
55. PowerPath supported. ATF/CDE not supported.
56. Firmware Version 2.70a5
57. Driver Version 9.1.4.17 Requires Microsoft STORPort hotfix Q943545. Please see http://support.microsoft.com/kb/943545. NOTE: Hotfix Q943545 requires a minimum of Service
Pack 1 (SP1) to be installed before the hotfix can be installed.
To obtain this hotfix, fill out the hotfix request form at http://support.microsoft.com/hotfix/KBHotfix.aspx?kbnum=943545&kbln=en−us STORPort Miniport Driver
58. BIOS 2.04
59. BIOS 3.03a3
60. Flex Address support requires BIOS v3.03a3
61. Flex Address support requires BIOS v2.04
62. Internal port(s) on QLogic or McData 4Gb FC switch module(s) must be set to 4Gb to SAN boot.
63. BIOS 3.02a6
64. Internal port(s) on Qlogic or McData 4Gb FC switch module(s) must be set to 4Gb (if 4Gb operation is required or to 2Gb if 2Gb operation is required)
65. Mixing 2Gb and 4Gb fibre channel expansion cards is not supported in this server.
66. This HBA is equivalent to the Emulex LPe12002
67. This HBA is equivalent to the Emulex LPe12000
68. This HBA is equivalent to the Qlogic QLE2562
69. This HBA is equivalent to the Qlogic QLE2560
70. NEC SigmaBlade servers are not supported with Windows 2003 SP1 (x86 and x64 versions.)
71. Requires IBM Multi−Switch Interconnect Module for IBM BladeCenter (39Y9314) installed in IBM BladeCenter H and with appropriate fibre channel switch modules to installed in bays
8 & 10.
72. PCI−Express slots 5,6,and 7 are disabled when system has 2 CPUs (2−socket).
73. This dual port HBA is only supported on DELL PE 6850 in the right−most slot (seen from the rear of the server chassis) marked "FC"
74. BIOS 1.06
75. PCI−X slots in this server only support low−profile hbas with low−profile brackets. Please ensure your HBA vendor has included the proper bracket to fit this server.
76. BX6xx−series systems use an embedded fibre channel controller. Contact Fujitsu Siemens to acquire the proper BIOS for the embedded fibre channel controller.
77. STORPort Miniport Driver
78. FCode Value 2.72a2
79. Driver Version 1.30a6 Requires Microsoft STORPort hotfix Q943545. Please see http://support.microsoft.com/kb/943545. NOTE: Hotfix Q943545 requires a minimum of Service Pack
1 (SP1) to be installed before the hotfix can be installed.
To obtain this hotfix, fill out the hotfix request form at http://support.microsoft.com/hotfix/KBHotfix.aspx?kbnum=943545&kbln=en−us STORPort Miniport Driver
80. Driver Version 2.00a1
81. Driver Version 9.1.4.15 Requires Microsoft STORPort hotfix Q943545. Please see http://support.microsoft.com/kb/943545. NOTE: Hotfix Q943545 requires a minimum of Service
Pack 1 (SP1) to be installed before the hotfix can be installed.
To obtain this hotfix, fill out the hotfix request form at http://support.microsoft.com/hotfix/KBHotfix.aspx?kbnum=943545&kbln=en−us Max number of iFCP session for a single iFCP
port is 16. please review supporting documentation for complete details
82. Booting from the SAN with PowerPath is supported. Refer to the Path Management Software section for supported versions of PowerPath.
83. Firmware Version 2.72a2 Available in the EMC−approved section of the Emulex website. http://www.emulex.com
84. BIOS 3.03a9
85. FSC Fibre Channel module. Dual channel 4GBit/s HBA for BX6xx−series blade servers only.
86. Virtual machines running on VMWare ESX are supported booting from the array.
87. VMWare ESX Server itself is supported booting from external array.
88. BIOS 1.24
89. Driver Version 9.1.2.15 Requires Microsoft STORPort hotfix Q943545. Please see http://support.microsoft.com/kb/943545. NOTE: Hotfix Q943545 requires a minimum of Service
Pack 1 (SP1) to be installed before the hotfix can be installed.
To obtain this hotfix, fill out the hotfix request form at http://support.microsoft.com/hotfix/KBHotfix.aspx?kbnum=943545&kbln=en−us STORPort Miniport Driver
90. Driver Version 9.1.7.45 Requires Microsoft STORPort hotfix Q943545. Please see http://support.microsoft.com/kb/943545. NOTE: Hotfix Q943545 requires a minimum of Service
Pack 1 (SP1) to be installed before the hotfix can be installed.
To obtain this hotfix, fill out the hotfix request form at http://support.microsoft.com/hotfix/KBHotfix.aspx?kbnum=943545&kbln=en−us STORPort Miniport Driver
Microsoft Windows 2003 [x86]
CLARiiON AX150
03/04/2009 128 CLARiiON AX150