Filter
Top Products
Reset All
All printer settings for all interfaces have been reset to the
default configuration.
Reset to Save
You have changed a SelecType setting but the new value is not
activated yet. Do one of the following: (1) exit SelecType by
pressing Continue or On Line (the new setting is activated
after the current print job is finished), or (2) reset the printer by
pressing ALT and Reset at the same time.
Self Test
The printer is performing its internal self test; wait a few
moments for it to finish.
Service Req.C
nnn
Service Req.E
nnn
A controller error (C
nnn
) or a print engine error (E
nnn
) has
occurred. Write down the error number and turn off the
printer. Wait at least five seconds and then turn it back on. If
the error message still appears, turn off the printer, unplug the
power cord, and contact an authorized EPSON Customer Care
Center.
Standby
The printer is in its low power state. If the On Line light is on, it
is still on line and you may send a print job.
Toner Low
The printer is almost out of toner. You should replace the
imaging cartridge soon; see Chapter 5 for instructions.
6-6
Troubleshooting