Filter
Top Products
The font selected in your software won’t print correctly.
The selected font is not supported by your printer; see
the Introduction or the
Technical Information
manual for more
information.
If Image Optimum is set to Auto or On, fonts may be changed
to increase print speed. Set Image Optimum to Off in the
printer driver or the SelecType Config menu; see Chapters 2
and 3 for details.
The output is garbled or printed as asterisks (*).
If you use the Remote Control Panel, check whether any
settings have been changed by another user; see the
Technical
Information
manual for details.
Make sure that both ends of the interface cable are plugged in
securely. Also be sure you use a double-shielded, twisted-pair
parallel interface cable no longer than six feet in length for
Parallel B; no longer than 30 feet in length for Parallel C.
If you are using an optional serial interface, set the parity, baud
rate, number of data bits, and number of stop bits to match
your computer; see your computer manual for details.
The emulation setting for that port may not be correct. Specify
the emulation mode with SelecType (see Chapter 3) or the
Remote Control Panel utility (see the
Technical Information
manual).
If the printer still does not print correctly, contact your dealer
or an authorized EPSON Customer Care Center.
The position of the printout on the page is incorrect.
Make sure you are using the correct page length and margin
settings in your application program.
6-12
Troubleshooting