Filter
Top Products
Input buffer
The input buffer stores up to 32KB of data sent from your
computer, freeing your computer for other tasks while the
printer prints. When the buffer is off, the buffer cannot store
data, so the computer must wait for the printer to print each
character before sending the next character.
Buzzer (beeper)
The printer beeps when an error occurs. See page 7-2 for more
information on printer errors. If you do not want the printer to
beep when an error occurs, turn off this setting.
Auto CR (carriage return)
This setting is available only in IBM 2380 Plus/2381 Plus
emulation mode. When auto carriage return is on, each line
feed (LF) code or ESC J code is accompanied by a carriage
return (CR) code so the printer moves the next printing position
to the left margin. When this setting is off, you must send a CR
code after the line feed code to move the printing position to
the left margin.
IBM character table
This setting is available only in IBM 2380 Plus/2381 Plus
emulation mode. When you select Table 1, hex codes 00H to
1FH and 80H to 9FH of the character tables are used for the
control codes. When you select Table 2, hex codes 00H to 1FH
are used for the control codes and 80H to 9FH are used for
characters. See Appendix C for character samples.
5
R
Gentian-W Rev.C
A5 size Chapter 5
11/14/97 pass 0
Changing Printer Settings From the Printer’s Control Panel
5-7