Filter
Top Products
2. Place the base plate on the stand and fasten the two together with the
plastic spacing clips. Make sure you orient the stand and base plate as
shown below.
3. Hook the tension lever onto both ends of the stand as shown below.
While pulling up on the tension lever, fit the wire ends of the tension
lever into the holes in the stand. The roll paper holder is assembled.
Installing the roll paper holder
To install the roll paper holder on your printer, follow the steps below.
1. Make sure the printer is turned off.
2. Remove the paper guide, then remove the tractor if it is installed in the
pull or rear push position. Reinstall the paper tension unit if
necessary.
g3-30-2
tension lever
g3-30-3
g3-35
A
R
Gentian-W Rev.C
A5 size Appendix A
11/14/97 pass 0
Enhancing Your Printer With Options
A-21