Filter
Top Products
Removing the tractor from the front push position
To remove the tractor from the front push position, follow the
steps below.
1. Make sure the printer is turned off.
2. Remove any paper from the tractor as described in the
previous section.
3. Press the tractor’s lock tabs, tilt the tractor up, and lift it out of
the printer.
Using the Tractor in the Rear Push Position
The tractor is installed in the rear push position when the
printer is shipped. If your tractor is in the rear push position,
skip to “Loading paper with the rear push tractor” on page 3-15
for instructions on loading continuous paper.
Note:
Thick paper, such as continuous paper with labels or multi-part forms
with five or six parts, requires a relatively straight paper path to avoid
paper jams. When printing on thick continuous paper, use the tractor in
the front push position or the pull position.
!fx3-8
3
R
Gentian-W Rev.C
A5 size Chapter 3
11/17/97 pass 1
Printing on Continuous Paper
3-13