Filter
Top Products
Too many sheets are loaded in
the cut-sheet feeder. You
cannot load more than 150
sheets of paper in the
high-capacity cut-sheet feeder.
Load less than 150 sheets of paper. See
Appendix A for more information.
The edge guides of the
cut-sheet feeder are not
positioned correctly.
Align the left edge guide with the
arrow mark, then move the right edge
guide to match your paper’s width.
There is only one sheet left in
the bin.
Add more paper to the cut-sheet feeder.
The printer does not load continuous paper or does not feed it
properly.
Cause What to do
The paper release lever is not
set correctly.
Set the paper release lever to the
position for the paper source you want
to use. For more information on setting
the paper release lever, see the section
in Chapter 3 on loading paper with the
tractor you want to use.
Single-sheet paper is in the
paper path.
Press the Load/Eject button to eject
the sheet.
Continuous paper is not
loaded properly.
See Chapter 3 for instructions on
loading continuous paper with the
tractor you want to use.
The paper thickness lever is
not set correctly.
Set the paper thickness lever to match
the thickness of your paper. See
“Setting the Paper Thickness Lever” in
Chapter 3.
L
Gentian-W Rev.C
A5 size Chapter 7
11/17/97 pass 0
7-6
Troubleshooting