Filter
Top Products
Character Tables
You can select the character tables shown in this section with the printer’s
default-setting mode or by using software commands.
Note:
Most of the character tables are the same as the PC 437 table for hex codes 00
through 7F; for these tables, only the characters for hex codes 80 through FF
are shown.
The character tables with an asterisk (*) after the table name are available
only in some countries.
You can choose between the two IBM character tables shown below when
you select IBM 2380 Plus/2381 Plus emulation in the default-setting
mode, as described in Chapter 5. (When you select Table 1, hex codes 00
to 1FH and 80 to 9FH are replaced; when you select Table 2, hex codes 00
to 1FH are replaced.)
Table 1 Table 2
C
R
Gentian-W Rev.C
A5 size Appendix C
11/14/97 pass 0
Specifications
C-17