Filter
Top Products
To perform a self test, follow these steps:
1. Make sure paper is loaded and the printer is turned off.
c
Caution:
Whenever you turn off the printer, wait at least five
seconds before turning it back on; otherwise you may
damage the printer.
2. To run the test using the Draft font, hold down the LF/FF
button while you press the Operate button to turn on the
printer. To run the test using the printer’s near letter-quality
fonts, hold down the Load/Eject button while you turn on
the printer. Either self test can help you determine the
source of your printing problem; however, the draft self test
prints faster than the near letter-quality test.
After a few seconds, the printer loads the paper automatically
and begins printing the self test. A series of characters is
printed.
Note:
To temporarily stop the self test, press the
Pause
button. To resume
the test, press the
Pause
button again.
3. To end the self test, press the Pause button to stop printing.
If paper remains in the printer, press the Load/Eject button
to eject the printed page. Then turn off the printer.
c
Caution:
Do not turn off the printer while it is printing the self test.
Always press the
Pause
button to stop printing and the
Load/Eject
button to eject the printed page before you turn off
the printer.
L
Gentian-W Rev.C
A5 size Chapter 7
11/17/97 pass 0
7-16
Troubleshooting