Filter
Top Products
8. Attach the stacker-support wires to the paper guide as shown below, if
necessary.
9. Install the paper guide with the attached stacker-support by fitting the
notches on the paper guide straight down over the mounting posts on
the printer. Slide the edge guides to the middle of your paper.
The cut-sheet feeder automatically loads paper when the printer receives
data.
If the first line on your page appears too high or low, you can adjust its
position using the micro adjust feature. See “Adjusting the Top-of-Form
Position” on page 3-35.
g4-7-1
g4-9
A
R
Gentian-W Rev.C
A5 size Appendix A
11/14/97 pass 0
Enhancing Your Printer With Options
A-9