Filter
Top Products
7. Set the paper release lever to the pull tractor position. Then
use the micro adjust mode (described on page 3-35) to
remove any slack in the paper between the push and pull
tractors.
8. Move the paper release lever back to the position you set in
step 3.
9. When the printer receives data, it will start printing at the
current position without advancing the paper. If necessary,
follow the steps in “Adjusting the Top-of-Form Position” on
page 3-35 to adjust the current position of the paper.
10. Attach the printer cover. Make sure the paper guide is
installed and lying flat on the printer, and the continuous
paper support is in the upright position.
11. Send a print job to the printer. The printer starts printing
from the current position without advancing the paper.
After you finish printing, tear off the printed document at
the perforation nearest the paper exit slot.
fx05
3
R
Gentian-W Rev.C
A5 size Chapter 3
11/17/97 pass 1
Printing on Continuous Paper
3-31