Filter
Top Products
It is best to select the paper path in your application program because
software settings usually override the printer’s control panel settings.
However, if you cannot select the paper path in your application, select a
path by pressing the Tear Off/Bin button until the light indicates the bin
you want as shown below.
The cut-sheet feeder you selected automatically loads paper when the
printer receives data.
Using an Optional Front Sheet or Front Paper Guide
The optional front sheet guide (C81400 /C80401 ) and front paper guide
(C81402 /C80403 ) fit inside the front of the printer. These options allow
you to load single sheets and carbonless single-sheet multi-part forms of
up to 6 parts (one original and five copies). Paper used with front guides
must be 148 to 257 mm (5.8 to 10.1 inches) wide and can only be loaded
one sheet at a time.
The optional front sheet guide provides you with the best paper jam
prevention, but you need to remove the tractor from the front push
position to use it. You can use the optional front paper guide without
removing the tractor from the front push position.
The installation and paper loading procedures described below apply to
both the front paper guide and the front sheet guide. Separate illustrations
are provided where necessary; please refer to the appropriate illustrations
when installing and using these options.
n
= On
o
= Off
f
= Flashing
A
R
Gentian-W Rev.C
A5 size Appendix A
11/14/97 pass 0
Enhancing Your Printer With Options
A-15