Filter
Top Products
Rev.A OS and Driver Setup 2-3
Developer's Guide SR-600
Confidential
Type the command written below on the prompt to install the driver.
MEDVSTD I10,P2E8,B96[Enter]
Parameter “I10" specifies IRQ 10, “P2E8" specifies I/O address 2E8h, and “B96" specifies Baud
Rate 9600.
The calibration method is as follows.
1. Move to the Touch Panel directory.
2. Type “EPCAL” then press [Enter]. Calibration utility starts.
3. Click on the points on the [+] character. The [+] character is displayed sequentially in nine
places on the screen (Top : left/middle/right, Middle : left/middle/right, Low : left/
middle/right).
4. It automatically exits the utility when the procedure is completed.
Network Driver
The driver for Microsoft Lan Manager is stored in “C:\BACKUP\NETWORK\MSLANMAN"
directory, and the driver for Novell Netware is stored in
“C:\BACKUP\NETWORK\NWCLIENT” directory. The installation instruction is indicated in
“MSLANMAN/MSLANMAN.TXT” for Microsoft Lan Manager Drive, and “NWCLIENT/
NWODIDOS.TXT” for Novell Netware Drive. Refer to those instructions for the installation.
The directories explained above is for backup and is not a directory configuration of the
document. Make sure to create an appropriate directory, then proceed the copying of the file.
CD-ROM Driver
The CD-ROM Driver is not installed when this unit is shipped. Follow the steps below to install
the CD-ROM Driver.
1. Start “C:\BACKUP\CDROM\INSTALL.EXE”.
2. The Installation Menu Screen is displayed.
Ordinarily, item 2 is selected.
3. “AUTOEXE.BAT” Updated Selection screen is displayed.
Press “Y" then [Enter].
4. Start the searching of the fie then exit.
The searching of the file is a required process for Windows, but not necessary for MS-DOS.