Filter
Top Products
Rev.A BIOS Setup 3-11
Developer's Guide SR-600
Confidential
PASSWORD
When you select this function (SUPERVISOR PASSWORD or USER PASSWORD) from the main
menu, a message explained below appears at the center of the screen: then enter the password.
Password distinguishes upper and lowercase characters and can have up to 8 characters.
ENTER PASSWORD:
Typing a password clears any previously entered password.
The following message appears next.
CONFIRM PASSWORD:
Again, type the password and press
Ente
r.
To clear the password, simply press
Enter
when asked to enter a password. Then the password
function is disabled.
To abort the process at any time, press
Es
c.
Power On Self Test (POST)
Power On Self Test (POST) checks the system configuration and hardware while power is on. If
it detects any errors, it issues error messages and emits audible beeps. The following section
explains the error messages.
POST Messages
During the POST, the BIOS either sounds a beep code or displays a message when it detects a
correctable error. The following is a list of POST messages. An error message may be followed
by a prompt to press
F1
to continue or press
DEL
to enter Setup
.
Table 3-8 POST Messages
Message Description
Beep The only beep code indicates a video error has occurred and BIOS cannot
initialize the video screen to display any additional information. This beep
code consists of a single long beep followed by two short beeps.
CMOS BATTERY HAS FAILED CMOS battery is no longer functional. It should be replaced.
CMOS CHECKSUM ERROR Checksum of CMOS is incorrect.
This can indicate that CMOS has become corrupt.
This error may have been caused by a weak battery.
Check the battery and replace if necessary.