Filter
Top Products
Rev.A Hardware Specifications 5-13
Developer's Guide SR-600
Confidential
For the Ethernet controller, the RTL8139B/C(L) for PCI connection is used. Both 10 Mbps and
100 Mbps operation, and wake-up from the LAN is available. Booting program from the
network is stored in the optional Flash Memory.
However, while AC power is not provided(including main power switch is off) and the power is
off, wake-up is not available. To enable wake-up, it is necessary to enable Wake Up On LAN
from the BIOS Setup and to turn on the main power.
This controller can be set from the BIOS setup so that it cannot be used.
Others
Lithium Rechargeable Batteries
The SR-600 is internally equipped with a Vanadium Lithium rechargeable battery(VL2330)
which backs up the RTC in the CMOS RAM. This battery, which uses +5V, is recharged
when the main power switch is turned on and the system is in operation.
Charging time: 40 hours
Backup time: 200 days (when completely charged)
WARNING:
Do not attempt to open, disassemble, deform or put in the fire the Vanadium-Lithium battery,
which could result in burns or release of hazardous chemicals.
When you dispose of the Vanadium-Lithium battery, insulate it by wrapping the terminals with
tape. Do not mix with other metals or batteries; this may lead to fire, heat, or explosion.
When the Vanadium-Lithium battery is shipped from the factory, it is not fully charged.
Therefore, “CMOS chcksum error” message might be displayed when you turn on the main
power for the first time. Press the F1 key to set the default value to CMOS.