Filter
Top Products
Formatter Assembly
1 If the Formatter is to be replaced, make sure to note the page count.
2 Loosen the two captive screws (Figure 6-24, callout 1) and slide the
Formatter PCA out of the chassis.
3 After installation of a replacement Formatter, be sure to re-enter the serial
number, page count, and maintenance count. (See the following
instructions for more information.)
Formatter Assembly
Caution
The Heavy Media C3124A (5Si HM) has a Thermal Control PCA and wiring
harness. The Thermal Control PCA is located in a SIMM slot on the
formatter and must be removed and reinstalled on the replacement
formatter. The formatter PCB is unique for the C3124A. See the parts
section for correct ordering.
Figure 6-24
6-38 Removal and Replacement