Filter
Top Products
Tray 2/3 Assemblies
Note
The paper trays are mechanically aligned to the printer chassis at the
factory. If you are replacing Tray 2 or Tray 3 with a tray other than the
original factory installed unit, you may have to adjust the new tray. For
details, refer to the Tray 2 and 3 Adjustment Procedure in Chapter 4.
1 Open the tray and pull it out to the stop.
2 Carefully lift up on the outer end to release the tray stop mechanism at the
right rear while continuing to pull the tray free of the chassis.
To Reinstall:
1 Align the left rear corner of the tray and the locating track at the lower rear
center of the tray with their respective guides, and insert the tray no more
than two inches into the chassis.
2 Carefully lift up on the outer end of the tray while pulling the tray stop
mechanism, located at the right rear of the tray opening, out and over the
tray roller and guide assembly.
3 Carefully slide the tray into the printer until it latches into place.
6-66 Removal and Replacement