Filter
Top Products
Motor, Transport Belt and Encoder Assembly
1 Remove the left cover (see Figure 6-65).
2 Remove all paper bins and the blind cover (see Figure 6-86).
3 Remove the Controller PCA (see Figure 6-87).
4 Remove (2) screws, CH112, from the motor assembly (Figure 6-83, callout 1).
5 Remove the small drive belt (Figure 6-84, callout 2) from the motor drive
gear.
6 Pull the motor and Encoder Assembly clear of the frame while guiding the
cables through the access hole in the bottom of the frame.
To Reinstall:
1 Make sure that the segmented disk at the back of the Transport Belt Motor
is approximately centered in the Encoder Assembly photosensor
(Figure 6-85, callout 3).
2 Replace the drive belt on the motor drive gear before installing and
tightening the screws.
Multi-Bin Mailbox/Mailbox with Stapler, Transport Belt Motor Screws
Figure 6-83
6-96 Removal and Replacement