Filter
Top Products
Message Error
Log
Category/
Message
Description Recommended
Action
58.x PRINTER ERROR
CYCLE POWER
Service
Message
58.01.00
58.02.00
58.03.00
58.04.00
The tray lifter malfunctioned. The tray lifter
mechanisms lift the paper stack in each tray
until the paper is located directly beneath the
feed rollers. To watch Tray 3 lift, remove Tray
2 and use Tray 2’s cavity to see Tray 3 move
into position during power-on. To watch Tray
2 being lifted, remove the duplexer, if
installed, and through the duplex paper jam
access door, watch Tray 2 being lifted during
power-on. To watch Tray 4 being lifted, open
the Vertical Transfer Door and then open and
close Tray 4. Override the Vertical Transfer
Door closed photosensor (PS35)(refer to
Figure 7-16) and see if Tray 4’s paper stack
is being lifted.
58.1 = Tray 2 lifter malfunction
58.2 = Tray 3 lifter malfunction
58.3 = Tray 1 lifter malfunction
58.4 = Tray 4 lifter malfunction
Press [Select] to continue. The
printer will ignore the faulty tray
until the next power cycle. Cycle
power. If the message persists for
Trays 1, 2 and 3: Replace the
Paper Input Assembly.
Replace the Main Gear Assembly.
For Tray 4, check the white
bushing, located on the lower part
of the Main Drive Assembly (refer
to Figure 6-56). Replace Tray 4.
Replace the Gear Assembly.
59.x PRINTER ERROR
CYCLE POWER
Service
Message
59.01.00
59.02.00
The Main Motor is powered by +24VB, which
is generated when Switch 1401 on the
Switch/Sensor PCA closes.
59.1 = Main motor start up failure.
59.2 = Main motor rotation failure.
Cycle power. If the message
persists, replace the
Switch/Sensor PCA. Check and
reseat cabling between the main
motor and DC Controller PCA
(J218). Replace the main motor.
Replace the DC Controller.
NOTE: To determine if the Main
Motor is rotating, turn on the
printer and see if the top
face-down stacker rollers are
rotating.
61.x PRINTER ERROR
CYCLE POWER
Service
Message
61.0x.00
The printer encountered a parity error when
accessing either internal memory (x = 0), or
SIMM memory (x = 1-4).
Cycle power. If the message
persists: Verify that the SIMM
module is installed correctly. Turn
off the printer, remove the SIMM
module, then turn on the printer. If
the message does not display,
replace the defective SIMM. If the
message continues, turn off the
printer and remove the next
SIMM module, then turn on the
printer. Repeat this step for the
remaining SIMM modules until
the problem is isolated. If the
message continues with no
SIMMs installed, replace the
Formatter PCA.
Table 7-5 Printer Control Panel Messages (continued)
7
Troubleshooting
Troubleshooting 7-53