Filter
Top Products
Message Error
Log
Category/
Message
Description Recommended
Action
66.2.1 DEVICE ERROR
CYCLE POWER
Service
Message
66.02.01
Home reference is not found. During the
power-on sequence, the Multi-Bin Mailbox
and the delivery head travel the length of the
mailbox verifying that all the bins and the
stapler are installed. This is performed when
the PS Bin Full/Head Position photosensor,
located in the Head Assembly, reads a scan
bar. A scan bar forms by plastic protrusions
located on the rear surface of each bin and
the stapler (refer to Figure 7-12). When all
the bins are in place, one continuous scan
bar is formed.
Roll the mailbox assembly away
from the printer. Inspect the front
of the mailbox to determine if one
continuous scan bar is present
(refer to Figure 7-12). Each bin,
and the stapler assembly, if
installed, MUST be in place to
form a continuous scanbar.
Ensure the stapler is firmly
seated on to the mailbox and
ensure all mailbox trays are in
place. With the 8-bin mailbox,
ensure the Blind Cover is
installed. Verify the Multi-Bin
Mailbox Head assembly can
move freely.
Override the Mailbox Interlock
switch (Figure 7-25) then
power-on the printer and observe
the mailbox head assembly go
through the normal power-up
sequence.
If the preceding actions do not
correct the error, replace the
Multi-Bin Mailbox.
66.2.2 DEVICE ERROR
CYCLE POWER
Error
Message
66.02.02
One or more bins were not found. Make sure that all bins are
properly installed. Check the bins
for damage (refer to Figure 7-12).
Table 7-5 Printer Control Panel Messages (continued)
7-56 Troubleshooting