Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3)
8
-
58
Replacing the Power/Communication Board (A000368) (continued)
Steps Procedure
7 Use a Torx T-10 screwdriver to remove the two (2) screws (F000169) that
secure the Power/Communication Board Cover (D900026) to the Printer
Baseplate (D900000). See below.
8 Disconnect the Communication Ribbon Wire (D900034) from the J3 Power
Board connection.
9 Use a Torx T-10 screwdriver to remove the two (2) screws (F000169) that
secure the Printer Power/Communication Board (A000368) to the Printer
Baseplate. See below.
10 Remove and replace the Power/Communication Board (A000368). See
Replacing the Power/Communication Board (A000368)
.