Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3)
8
-
86
Replacing the Platen Roller (D900041) (continued)
Steps Procedure
6 Remove the Printhead. See Replacing the Printhead Assembly (D900023).
7 Use a Small Flathead Screwdriver to gently pry the Roller Shaft Locking Bushing
arm (D900046) out about 2mm.
8 Rotate the Roller Locking Shaft Bushing Counter Clockwise 1/8 of a turn, as
shown below.
9 Remove the Roller Shaft Locking Bushing.
10 Pull out the Platen Roller (D900041).
11
Replace the Platen Roller (D900041). (Note: Be sure to add the retaining clip
(140062) to the new Platen Roller before it is inserted into the Printer.)
12 Reverse to re-assemble.
Continued on the next page