Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3)
8
-
70
Replacing the Stepper Motor Assembly (D900087)
Refer to Drawing D900077
Tools Needed: Phillips Head Screwdriver.
Parts Needed: Stepper Motor D900087
Estimated Repair Time: 10 minutes.
Steps Procedures
1
Caution: Turn off the Printer and unplug the power cord from the
Printer.
2 Remove the Rear Cover. See Replacing the Rear Cover (D900066).
3 Remove the Input Door and Right End Cap. See Replacing the Input Door
Assembly (D900148). See Replacing the Right End Cap (D900065-01 and –02).
4 Remove the Card Output Door and Left End Cap. See Replacing the Output
Door Assembly (D900092). See Replacing the Left End Cap (D900064).
5 Remove the Baseplate Assembly. See Replacing the Baseplate (D900000).
6 Remove the Headlift Motor Assembly. See Replacing the Headlift Motor
Assembly (D900085).
Caution: The Headlift Ex. Spring (F000334) may spring out.
7 Remove the Stepper Motor Drive Belt. See Replacing the Stepper Motor
Assembly (D900087).
8 Use a Torx T-10 screwdriver to remove the three (3) screws (F000171) that
secure the Stepper Motor to the Printer. See the frontend display with this set of
procedures.
Continued on the next page