Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3)
8
-
94
Replacing the Card Feed or Exit Roller (D900042) and the Card Drive Gear
(810266) (continued)
Steps Procedure
8 Use a Small Flathead Screwdriver gently pry the Roller Shaft Locking Bushing
arm (D900046) out about 2mm.
9 Rotate the Roller Locking Shaft Bushing Counter Clockwise 1/8 of a turn, as
shown below.
10 Remove the Roller Shaft Locking Bushing.
11 Pull out the Card Exit Roller (D900042)
12 Replace the Card Exit Roller.
Caution: Be sure to add the retaining clip (140062) to the new
Cleaning Roller before it is inserted into the Printer.
13 Reverse to re-assemble.