Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3)
8
-
75
Replacing the Magnetic Head Assembly (D900050)
Refer to Drawing D900148.
Tools Needed: Torx T-10 Screwdriver.
Parts Needed: Magnetic Encoding Module
D900050
Estimated Repair Time: 5 minutes.
Steps Procedure
1
Caution: Turn off the Printer and unplug the power cord from the
Printer.
2 a. Remove the one (1) screw connecting the Magnetic Door Cover (D900107).
b. Pull out the Magnetic Encoder Assembly (D900050). See below.
3 Remove and replace the Magnetic Head Assembly (D900050). See next page.
4 Reverse to re-assemble.
Continued on the next page