Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3)
8
-
83
Replacing the Headlift Sensor Assembly (D900113)
Refer to Drawings D900110.
Tools Needed: Torx T-10 Screwdriver.
Parts Needed:
Estimated Repair Time: 20 minutes.
Steps Procedure
1
Caution: Turn off the Printer and unplug the power cord from the
Printer.
2 Remove the Rear Cover. See Replacing the Rear Cover (D900066).
3 Remove the Input Door and Right End Cap. See Replacing the Input Door
Assembly (D900148). See Replacing the Right End Cap (D900065-01 and –02).
4 Remove the Card Output Door and Left End Cap. See Replacing the Output
Door Assembly (D900092). See Replacing the Left End Cap (D900064).
5 Remove the Printer Baseplate. See Replacing the Baseplate (D900000).
6 Remove the Ribbon Take-up Motor Assembly. See Replacing the Ribbon Take-
up Motor (D900086).
Continued on the next page