Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3)
8
-
77
Sensor Replacement
Replacing the Ribbon LED Sensor Assembly (A000374 and
D900138)
Refer to Drawings D900078.
Tools Needed: Phillips Head Screwdriver.
Estimated Repair Time: 5 minutes.
Steps Procedure
1
Caution: Turn off the Printer and unplug the power cord from the
Printer.
2 Remove the Rear Cover. See Replacing the Rear Cover (D900066).
3 Remove the Input Door and Right End Cap. See Replacing the Input Door
Assembly (D900148). See Replacing the Right End Cap (D900065-01 and –02).
4 Remove the Card Output Door and Left End Cap. See Replacing the Output
Door Assembly (D900092). See Replacing the Left End Cap (D900064).
5 Remove the Top Cover Assembly. See Replacing the Top Cover Assembly (see
page 8-39).
6 Remove the Platen Roller. See Replacing the Platen Roller (D900041).
Continued on the next page