Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3)
8
-
72
Replacing the Ribbon Take-up Motor (D900086)
Refer to Drawings D900086 and D900077.
Tools Needed: Torx T-10 Screwdriver.
Parts Needed: Ribbon Take-up Motor Assembly
D900086
Estimated Repair Time: 10 minutes.
Steps Procedure
1
Caution: Turn off the Printer and unplug the power cord from the
Printer.
2 Remove the Rear Cover. See Replacing the Rear Cover (D900066).
3 Remove the Input Door and Right End Cap. See Replacing the Input Door
Assembly (D900148). See Replacing the Right End Cap (D900065-01 and –
02).
4 Remove the Card Output Door and Left End Cap. See Replacing the Output
Door Assembly (D900092). See Replacing the Left End Cap (D900064).
5 Disconnect the Ribbon Take-up Power cable.
6 Use a Torx T-10 screwdriver to remove the four (4) screws (F000177) that
secure the Ribbon Take-up Motor (E000806) to the Printer.
7 Pull the Ribbon Take-up Motor and Hub out of the Printer. See the frontend
display with this set of procedures.
8
Remove the Hub from the Motor Assembly. (Note: The Hub is pressure-fit
onto the Motor Shaft. It may require some force to remove it.)
9 Reverse to re-assemble.
Continued on the next page