Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3)
8
-
82
Replacing the RFID Sensor Assembly (A000365), Ribbon Encoder Wheel
(810492), Encoder Pulley (D900106) and Ribbon Supply Hub (D900090)
(continued)
Steps Procedure
7 Use a Retaining Ring Pliers to remove the Ribbon Supply Hub Retaining Ring
(140048) and slide the Ribbon Supply Drive Pulley (D900106) and Encoder
Wheel (810492) off the Shaft, as shown below.
8 Use a Flathead screwdriver to remove the retaining clip (140062) from the
Ribbon Supply Hub Shaft (D900090).
9 Use a Torx T-10 screwdriver to remove the two (2) screws F000177) That
secure the RFID Sensor Assembly (A000365) to the Printer.
10 Disconnect the RFID Sensor cable (D900112).
11 Replace the RFID Sensor Assembly (A000365).
12 Reverse to reassemble.