Filter
Top Products
5
5-31
GFK-1004B
Chapter 5 The Station Manager
SHOW Command
The SHOW command has the form:
SHOW { <parm name> | PARMS <task(s)> }
where <par m name> is the name of one of the parameters from Table 5-10.
or PARMS is entered just as shown and <tasks(s)> is a set of one or more task identifier
letters from the Table 5-3.
The SHOW command has one of two forms. If the argument to the SHOW command is
the string PARMS, then task identification letter(s) are also required. The list of configu-
ration parameters for the specified task(s) is displayed.
A typical SHOW PARMS command is shown below:
> show parms i
<<< IP Parameters >>>
iaddr inetmaskz idefgateway iname server ittl
ifrag_q_sz imax_frag ifrag_ttl ifrag_tmr
If a configuration parameter name is entered with the SHOW command, the current
value of that parameter is displayed. Valid configuration parameter names are listed in
the tables below.
A typical SHOW command is shown below:
> show ittl
ittl = 64 <0040H>
Note
Note that these parameters can not be changed using the Station
Manager. And only some (IP address, Subnet Mask, and Default
Gateway) can be changed using the PLC Programmer or GSM. All
others are fixed.