Filter
Top Products
E
E-3
GFK-1004B
Appendix E GEnet System Manager Data Link Error Codes
Table E-2. NDIS Error Codes
Error Code
(hexadecimal) Description
NDIS Error Codes 0000-000D and xxFF may be returned with Data Link Error
Codes 54-64. (* NDIS codes 0001-0005 are returned to the MAC. These codes
should never be indicated by the GSM.)
0000 Success or no additional error information.
0001* ReceiveChain is keeping RX buffer.
0002* Request was queued.
0003* Frame was not recognized.
0004* Frame was rejected.
0005* Forward RX frame to other protocol(s).
0006 MAC out of resources.
0007 Invalid parameter.
0008 Invalid function code.
0009 Function is not supported.
000A Hardware error during request (non-fatal). (may indicate network disconnection)
000B Transmit error; frame was not sent. (may indicate network disconnection)
000D Buffer was too small.
00FF General failure (non fatal). (may indicate network disconnection)
F1FF GEFNDIS resource error.
F2FF GEFNDIS duplicate LSAP error.
F3FF GEFNDIS LSAP not found error.
NDIS Error Codes 0020-002F may be indicated during Protocol Manager
installation (as PC is started) or when running Netbind utility. The error is
displayed as PROnnnnE, where nnnn is the NDIS error code.
0020 Driver already started.
0021 Binding was not complete.
0022 Driver was not initialized.
0023 Interface hardware was not found.
0024 Interface hardware failure.
0025 Configuration failure.
0026 Hardware interrupt conflict.
0027 Incompatible MAC.
0028 Initialization failed.
0029 Binding did not occur.
002A Network might not be connected.
002B Incompatible DOS version.
002C Driver is already registered.
002D PROTMAN.DOS pathname incorrect.
002E Insufficient DOS memory for PROTMAN.DOS to run.
002F Cannot access PROTOCOL.INI image.