Filter
Top Products
1
1-7
GFK-1004B
Chapter 1 Introduction
Quick Guide to the Manual
As you can see from Figure 1–2, the tasks to install the TCP/IP Communications System
fall into three categories:
1. GEnet System Manager (GSM) Tasks
2. Ethernet Interface Tasks
3. Logicmaster Configuration and possibly Programming Tasks
The table below breaks down these tasks and identifies where in the manual they are
described.
Tasks Where to go in the Manual
GEnet System Manager (GSM)
Installing, Starting Up, and
Using the GSM
Chapter 3. The GEnet System Manager
Section 1. Installing and
Starting–Up the GSM
Configuring Stations Chapter 3. The GEnet System Manager
Section 2. Configuring Stations
Downloading a Station Chapter 3. The GEnet System Manager
Section 3. Downloading a Station
Accessing the Station Manager
(Terminal Emulation Mode)
Chapter 3. The GEnet System Manager
Section 4. Accessing the Station Manager
Chapter 5. The Station Manager
Ethernet Interface
Installing the Interface Chapter 2. Installing the Ethernet Interface
Procedure 1. Installing the Interface
Powering–Up the Interface Procedure 2. Verifying Proper Power–
Up of the Interface
Configuring the Module
(Setting Soft Switch Configuration)
Procedure 3. Configuring the Interface
with the Logicmaster 90-70
Configurator
Field Network Tests Procedure 5. Testing the TCP/IP Interfaces on
the Network
PING Application Connection Tests Procedure 6. Pinging the TCP/IP Interfaces on
the Network
Monitoring the Station and
Managing the Network
Chapter 5. The Station Manager
Troubleshooting the Interface on
the Network
Chapter 6. Troubleshooting
Logicmaster Configuration/Programming
Configuring the Module
PLC Ladder Programming (COMMREQ)
Chapter 2. Procedure 3. Configuring the Interface
with the Logicmaster 90-70
Configurator
Chapter 4. Programming Communications Requests