Filter
Top Products
E
section level 1
figure_ap level 1
table_ap level 1
E-1
GFK-1004B
Appendix E GEnet System Manager Data Link Error
Codes
The GEnet System Manager Data Link error codes are described in this appendix. The
NDIS error codes used by the Network GSM and by the NDIS Protocol Manager are also
described.
Table E-1. GEnet System Manager Data Link Error Codes
Error Code Description
1 Too many LSAPs.
2 LSAP not registered.
3 DLI task not registered.
4 Out of buffers - dliact routine.
5 Out of buffers - dlideact routine.
6 Out of buffers - dlisend routine.
7 Out of buffers - dligetbuf routine. Restart GSM.
8 Bad return code - dxprec routine.
9 Command error - bus boot.
10 Command error - open window.
11 Open load file error.
12 Command error - boot data.
13 Command error - end of file.
14 Command error - sense.
15 Out of buffers - GrantBuf routine.
16 Bad type - GrantBuf routine.
17 Power on diagnostics error.
18 Power on diagnostics timeout.
19 MP400 busy - DXPsend routine.
20 Controller failed to enter run state.
21 In ring failed.
22 Hardware reset failed.
23 Send maintenance interface block timeout.
24 Maintenance interface block response error.
25 Send communication block timeout.
26 Bad input command.
27 Received communication block response timeout.
28 Communication block status error.
29 Unknown LSAP.
30 Receive data timeout.
31 Send data timeout.