Filter
Top Products
2
2-28 TCP/IP Ethernet Communications User’s Manual – January 1996
GFK-1004B
This TEST ALL command and report shows performance over the network between the
initiating node and each responding node, at a rate comparable to what an application
might experience. For further information, see the descriptions of the TEST and REPORT
commands in Chapter 4.
Verify that all GEnet stations under test are included in the list, either as the initiating node
or as a responding node. Also, all GEnet stations should report,
3e8H Responses received,
0H Responses with error, and
0H No Responses. (A No Response will occur occasionally. But, on average, a
No Response should occur no more than once with the TEST command above
executed with 40,000 frames instead of 1,000 frames.)
Transcribe this report onto a clean copy of the Ethernet Network Test Data Sheet
found in Appendix F, Forms. If you are testing a network with many nodes, you
may need more than one data sheet.
6. When the TEST ALL command has completed and its results have been transcribed,
gather the accumulated error log and LLC and MAC tallies from all GEnet stations
by sending the following commands to each station. Transcribe all non–zero results
to the Data Sheet.
$ rem <node> log
$ rem <node> tally l
7. Get the exception log and LLC and MAC tallies from the initiator by issuing the
following commands:
$ log
$ tally l
Transcribe all non–zero results to the Data Sheet.
The LOG response from each node, including the initiator, should appear as follows:
REM$ <<<Exception Log>>>
REM$ Exception log empty
Make a notation on the Network Test Data Sheet that the log is empty, or record the values,
if any, reported in the log response message.
The TALLY L response from each station should appear as follows:
REM> <<< Data Link Tallies >>>
REM> Unreg = 0000H Lsap0 = 0000H LsapOfl = 0000H EthUnreg = 0000H
REM> MacErr = 0000H BufProb = 0000H UnrecPdu = 0000H TstRcvd = 0000H
REM> TstResp = 0000H
REM>
REM> <<< MAC Tallies >>>
REM> SQEErr = 0000H MisdPack = 0000H FrameErr = 0000H SuccOne = 0000H
REM> CrcErr = 0000H RbufErr = 0000H LateCol = 0000H LostCarr = 0000H
REM> BsyCar = 0000H NoRtry = 0647H SuccMore = 0000H FRtry = 0000H