Filter
Top Products
3
3-12 TCP/IP Ethernet Communications User’s Manual – January 1996
GFK-1004B
Unusual Procedures
Updating or Adding to Existing GSM Software
Whenever you purchase the TCP/IP Ethernet Software, whether for the first time or as
an update, you receive all three parts: the Configuration Editor, the Communications
Software, and the GSM Software.
Normally, you will install all three parts of this software when you purchase it the first
time. If you receive an update, or are adding a new GEnet product, you may install all
or part of this software as appropriate. To install a specific part, follow the instructions
below.
1. To install only the LAN Interface Configuration Editor, type:
C:\GSM> a:install c
2. To install only the LAN Interface Communications Software, type:
C:\GSM> a:install x
3. To install only the GSM Software, type:
C:\GSM> a:install g
4. To install all 3 components, type:
C:\GSM> a:install
Changing the PC Network Card
If you change the PC network card type for any reason, follow the instructions below.
1. Power down the PC. Remove the existing PC network card. Follow the
manufacturer’s instructions to install the new PC network card.
2. Power up the PC. Change directory to the GSM directory.
C:\> cd\gsm
3. Run the LANIFSET utility.
C:\GSM> lanifset
4. This utility accesses the same menu as found in step 7 of the section, “Installing the
GEnet System Manager (GSM) Software”. Complete the remaining steps of that
section. This section describes the hardware requirements for running the GEnet
System Manager (GSM) software, and tells you how to install the GSM on the hard
disk of your personal computer.