Filter
Top Products
186 MFP disassembly/assembly ENWW
5 Reinstall the above parts following the
removal steps in reverse.
CAUTION Check that the orientation
of the roller is correct when
installing.
Check that no grease or
the like remains on the
roller.
Replacing the separation roller
rubber
Procedure
1 Remove Tray 1 and place the tray upside
down.
2 Remove two screws to remove the bottom
plate assembly.
3 Remove the spring.
4 Remove the separation roller assembly
from Tray 1.
5 Remove the snap ring to pull out the shaft
and remove the separation roller rubber
from the separation roller.
6 Reinstall the above parts following the
removal steps in reverse.
CAUTION Check that the orientation
of the separation roller is
correct when installing.
Check that no grease or
the like remains on the
separation roller.
There are three spring
holes. Insert the spring in
the middle hole.
Screws (2)
Bottom plate
assembly
Spring
Spring hole