Filter
Top Products
http://www.hp.com/go/clj9500mfp
294 Chapter 9 – Problem solving
Rev. 1.0
The job was not stapled. Jobs that are sent to the stapler or multifunction finisher might not be stapled for one
or more of the following reasons:
• One-page jobs are not stapled.
• The stapler is out of staples and AUTO CONTINUE is set to ON.
• The wrong size or type of media was used for the job.
• More than 50 pages were sent to the stapler, exceeding its capacity.
• The stapler has bent or broken staples in the stapler head.
• A staple jam was recently cleared (up to two sequential jobs might not be
stapled).
• The job was sent to a bin other than the stapler bin because the wrong size or
type of media was used for the job.
• The interface cable to the stapler unit might be defective or not connected
correctly.
Situation Solution