Filter
Top Products
http://www.hp.com/go/clj9500mfp
70 Chapter 4 – Faxing
Rev. 1.0
4 Type a phone number by using the keyboard that appears on the control-panel display.
Note If a two-second pause is needed, type a comma (,) after a prefix number (such as a “9” or “0”) to allow the
internal phone system time to reach an outside line before the remainder of the number is dialed.
5 To specify additional phone numbers, touch N
EXT NUMBER.
Note To remove a number from the list, scroll to and highlight the number and then touch REMOVE.
6 Touch S
TART to send the fax. (You can touch START on the touch-screen or press the START button on the control
panel.)
Note When a fax is sent, it is first copied into memory. After the entire document is stored, the fax is sent and is
then deleted from memory.
Sending a fax by using speed dial
Use the following procedure to send a fax by using speed dia
l.
Note Before sending a fax by using speed dial, you must create a speed dial. To create a single speed dial or a
speed-dial group, see “To create a speed dial” on page 74.