Filter
Top Products
Reduce or enlarge copies
Reduce or enlarge copies for the current job
1. On the product control panel, press Copy Features.
-or-
On products with a graphic display, press Copy Menu.
2. On the product control panel, press Reduce/Enlarge.
-or-
On products with a graphic display, press Size.
3. Select the size to which you would like to reduce or enlarge the copies in this job.
NOTE: If you select Custom: 25 to 400%, type a percentage by using the alphanumeric buttons.
If you select 2 pages per sheet or 4 pages per sheet, select the orientation (portrait or landscape).
4. Press Start Copy to save the selection and immediately start the copy job, or press OK to save the
selection without starting the job.
NOTE: The change in the setting remains active for about 2 minutes after the copy job has been
completed. During this time, Custom settings appears on the product control-panel display.
You must change the default media size in the media input tray to match the output size, or part of your
copy might be cut off.
Adjust the default copy size
NOTE: The default copy size is the size to which copies are normally reduced or enlarged. If you keep
the factory default size setting of Original=100%, all copies will be the same size as the original
document.
1. Press Setup.
2. Use the arrow buttons to select Copy setup, and then press OK.
3. Use the arrow buttons to select Default Reduce/Enlarge, and then press OK.
4. Use the arrow buttons to select the option for how you normally want to reduce or enlarge copies.
NOTE: If you select Custom: 25 to 400%, type in the percentage of the original size that you
normally want for copies.
If you select 2 pages per sheet or 4 pages per sheet, select the orientation (portrait or landscape).
5. Press OK to save the selection.
The product can reduce copies to as little as 25% of the original size or enlarge copies to as much as
400% of the original size.
Reduction/enlargement settings
●
Original=100%
●
Legal to Letter=78%
ENWW Use copy 75