IBM 63H3111 Printer User Manual


 
6. Hold the SIMM with the notch facing the socket (on DRAM SIMMs the notch goes
at the bottom; for flash memory, PostScript, or IPDS SIMMs the notch goes at the
top). Insert the SIMM at a 45 degree angle and move it into position in the socket.
Using your thumbs, press with even pressure on both ends of the SIMM until the
SIMM is firmly seated in the socket.
7. Make sure the clips on either end of the socket snap into place to hold the SIMM.
If necessary, use your thumbs to move the clips upright into the grooves to lock the
SIMM in place.
8. Verify that the SIMM is correctly installed in the socket by looking at its position
from the sides of the controller card.
9. If you are also installing a hard drive, go to step 5 on page 107.
Chapter 7. Installing Printer Options 103