Filter
Top Products
Table 7. Operator Intervention Messages and Parameters (OPINT TRAP Type) (continued)
OPINT #
Parameter
[A]
Parameter
[B]
Parameter
[C]
Actual Library Manager OPINT Trap
Message
57 Volser — — A volser (A) with an unknown media type
has been left in to the high-capacity input
station.
58 Volser — — An invalid volser (A) has been ejected to the
convenience I/O station
59 Rack Cell — — The cartridge label located at cell [A] has
an unknown media type.
60 Volser — — During an Inventory Update operation,
volser [A] was ejected to the convenience
I/O station because there were no free cells.
61 Volser — — During an Inventory Update operation,
volser [A] was ejected to the high capacity
station because there were no free cells.
62 Accessor — — Power failure on accessor [A]. A service call
is required.
63 Accessor — — Accessor [A] has failed. A service call is
required.
64 — — — Dual Write has failed. A service call is
required.
65 Volser Slot Rack Cell An Error occurred for cartridge [A] during
insert from CIO slot [B] to cell [C].
67 Volser — — Eject failed for volser [A]. This operation
was initiated by the Library Manager..
68 — — — A Library Manager switch has completed.
This switch was initiated by the operator.
69 — — — A Library Manager switch has completed.
This switch was due to an error.
70 — — — This message may appear as any of the
following:
1. A hard drive has failed. Call service
2. Primary hard drive has failed on LM-A.
Call service.
3. Primary hard drive has failed on LM-B.
Call service.
4. Mirror hard drive has failed on LM-A.
Call service.
5. Mirror hard drive has failed on LM-B.
Call service.
71 — — — This message may appear as any of the
following:
1. Hard drive is disabled. Call service
2. Hard drive is disabled on LM-A. Call
service.
3. Hard drive is disabled on LM-B. Call
service.
100 Volser VTS — A damaged stacked volume [A] has been
ejected.
Chapter 6. Advanced Operating Procedures 219
|||||
|
|||||
|
|||||
|
|||||
|
|
|
|
|
|
|
|
|
|
|||||
|
|
|
|
|
|