Filter
Top Products
3-2.Start-up Operation
6 DRYPRO MODEL 752 Operation Manual Ver.0.11 2002.6
3-2. Start-up Operation
Follow the procedure below to turn on the power of the equipment.
(1) Turn ON the power of the breaker located at the
lower-right of the device.
(2) Press the start switch below the control panel.
(3) The startup screen will appear.
(4) The WARMING UP screen will appear in approx. 2
minutes.
Breaker
Start switch
CAUTION
Pressing the start switch again turns OFF the
power. In this case, press the start switch again.
NOTE
• Although printing cannot be made during
warming up, the data from the diagnostic
devices can be received. The received data
will be printed out after the device goes into
the READY status.
• Settings on the maintenance can be made
during warming up.
• It takes approx. 25 minutes for the device to go
to the READY status. Note that it depends on
temperature around the device.