Filter
Top Products
4-3.How To Operate Maintenance Mode
DRYPRO MODEL 752 Operation Manual Ver.0.11 2002.6 39
(6) Touch the key on the right of the setting item, then
touch [
$] / [%] on the lower part of the screen to set
the following items.
DENSITY : Adjust the density of an image.
Selectable from -7 to 7.
Setting a negative value will make the den-
sity lighter, and a positive value, darker.
CONTRAST : Adjust the contrast of an image.
Selectable from -7 to 7.
Setting a negative value will make the con-
trast lower, and a positive value, higher.
SMOOTH TYPE : Sets the smoothing type of an image.
DEFAULT TRAY: Sets whether the upper or lower tray is pri-
oritized when the tray is not specified from
the diagnostic device.
(7) After the settings are complete, touch on the
upper part of the screen once.
The print preference set screen (3/7) will appear.
(8) Touch the key on the right of the setting item, then
touch the numeric keys on the lower part of the
screen to set the following items.
MAX DENSITY : Sets the maximum density of an image.
MIN DENSITY : Sets the minimum density of an image.
Lo : (Not used for the current version.)
La : (Not used for the current version.)
SORTER :
Sets the bin in the sorter (option) into which the
film is discharged.
(9) After the settings are complete, touch on the
upper part of the screen once.
The print preference set screen (4/7) will appear.
SMOOTH TYPE Settings
OFF Does not perform the magnification
interpolation.
1 Performs the Biliner interpolation.
2-6 Performs the Cubic Spline interpo-
lation.
Increasing the value will smooth an
image greater.
7 Does not perform the magnification
interpolation. But prints out in the
MAGNIFICATION setting. When
you wish to change this setting, ask
a service person.