Filter
Top Products
4-3.How To Operate Maintenance Mode
22 DRYPRO MODEL 752 Operation Manual Ver.0.11 2002.6
(8) Touch a LUT name you wish to apply for printing.
The selected LUT name will be highlighted.
(9) Touch on the upper part of the screen.
The print preference set screen (2/3) will appear.
(10) Touch the key on the right of the setting item, then
touch [$] / [%] to set the following items.
DENSITY : Adjust the density of an image.
Selectable from -7 to 7.
Setting a negative value will make the den-
sity lighter, and a positive value, darker.
CONTRAST : Adjust the contrast of an image.
Selectable from -7 to 7.
Setting a negative value will make the con-
trast lower, and a positive value, higher.
SMOOTH TYPE : Sets the smoothing type of an image.
SMOOTH TYPE Settings
OFF Does not perform the magnification
interpolation.
1 Performs the Biliner interpolation.
2-6 Performs the Cubic Spline interpo-
lation.
Increasing the value will smooth an
image greater.
7 Does not perform the magnification
interpolation. But prints out in the
MAGNIFICATION setting. When
you wish to change this setting, ask
a service person.