Filter
Top Products
5-3.Removing Jam
54 DRYPRO MODEL 752 Operation Manual Ver.0.11 2002.6
" Film jam between decent transport section
and exposure section
The screen on the right shows the example where a film jam
occurs between the decent transport section and the exposure
section (the subscan unit). Follow the procedure below to
remove the jammed film.
(1) Lift the film outlet cover on the front-lower part of
the device to open by lifting the green handle.
Opening the cover to an upright position fixes it with magnets.
(2) Turn the green handle located on the front-left until
the leading edge of film can be seen in the film out-
let.
The film in the descent transport section is transported to the
position control section.
(3) While turning the handle clockwise, put your hand
from the film outlet and fold the edge of the film
back.
(4) When the trailing edge of the film removes from the
transport roller, take out the film from the film outlet.
(5) Close the film outlet cover and then the front cover.
The normal screen will re-appear after a while when the mes-
sage of "PLEASE WAIT" appears.
When there queued print data remains, printing starts automat-
ically.
Green handle
Film outlet cover
Green edge
Film
CAUTION
The front cover cannot be closed with the film
outlet cover open. If you find it difficult to close
the front cover, check that the film outlet cover is
closed.
Do not close the front cover forcibly.