Filter
Top Products
4-3.How To Operate Maintenance Mode
42 DRYPRO MODEL 752 Operation Manual Ver.0.11 2002.6
• Setting user LUT
This device has LUTs recommended by Konica which are suitable for each type of diagnostic devices as a library. By
copying the LUT registered with the library to the user LUT in advance, it can be applied for the connected diagnostic
device.
Follow the procedure below to set the user LUT.
(1) Touch the user LUT name to be set on the LUT
select screen.
The selected user LUT name will be highlighted.
Up to 8 kinds of user LUTs can be set.
(2) Touch [LUT LIBRARY].
The LUT copy screen will appear.
(3) Select the type of the diagnostic device from the
seven keys on the upper part of the screen.
The name of the LUT that is suitable for the selected diagnostic
device appears on the eight keys displayed on the lower part of
the screen.
(4) Touch the name of the LUT to be applied.
The selected LUT name will be highlighted.
(5) Touch [OK].
The LUT information selected in Step (4) will be copied on the
user LUT selected in Step (1), then the LUT select screen will
appear.
Touching [GRAPH] will allow you to confirm a graph of the
selected LUT curve. (Refer to page 44.)