Filter
Top Products
7
Transmission applications
7-6 C450
Frame erase: When transmitting pages in a book, this function allows you to
erase dark bands that would otherwise be reproduced in the
marginal areas of the transmitted pages. (page 7-13)
Background adjustment: Function to send a message after adjusting the density in the
background color of the original. (page 7-16)
Sharpness: Function to send a message after making the edge of character
sharpened. (page 7-19)
Number of originals: In quick memory transmission, the total number of pages trans-
mitted can be included in the page number information.
(page 3-44)
Scan size: This function allows you to designate the size of the document
to be transmitted. It is convenient when you intend to transmit
part of a page or pages. (page 7-22)
File type: Specify the format of an attached file when sending a message
by e-mail. (page 7-25)
Quick memory TX: Function to send a message each time a page of document is
read. (page 3-42)
Password TX
*1
: Transmission can be sent with a password attached, as re-
quired when the receiving station is using a closed area com-
munication mode. (page 7-27)
Polling TX: This function allows you to read a document and store it in
memory until the destination initiates transmission by sending a
command to receive (polling). (page 9-3)
Polling RX: This function allows you to initiate reception by sending a com-
mand to a destination to receive a document that is set for
transmission at the destination. (page 9-6)
Timer TX: The time to start communication can be specified. (page 3-47)
F-code TX
*2
: This is a function in which the SUB address and the password
are specified to use the Confidential Communication, the relay
request, and the bulletin board. (page 7-27, page 7-30,
page 7-35, page 9-9)
Line setting Overseas TX A lower baud rate will be employed. (page 3-50)
ECM OFF Error correction mode (ECM) can be disabled. (page 7-38)
V.34 OFF When the V.34 protocol can not be used due to restrictions of
exchange equipment, the V.34 mode is disabled for transmis-
sion. (page 7-41)
Function Description
*1
: This can be used to transmit to receiving stations with closed area communication mode
selected.
It is impossible to communicate with a fax without F-code function.
*2
: F-code is used.